3 Series E46 330i (M54) SAL
Installation:
Before fitting new converter bell housing, check
measurement "A" between transmission housing (2) and pulse
gear (1) with special tool 00 2 550 .
Measurement "A" => approx.. 1 mm.
Pulse gear (1) must be situated below level of sealing
surface (2) of transmission housing.
Remove oil pump gasket (1).
Installation:
Insert new oil pump gasket with fixtures into bore holes in
accordance with hole pattern.
Installation:
-
Coat sealing rings (1) with petroleum jelly.
-
Remove sealing ring (2), grease with petroleum jelly and
reinstall.
Installation:
-
If necessary, remove shim from old converter bell housing.
-
Secure with petroleum jelly to new converter bell housing on
oil pump.
-
Insert with fixture in groove.
-
Note installation position.
RA Installing converter bell housing/oil pump repair kit (A5S 360R / 390R)
BMW AG - TIS
16.02.2013 01:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
