3 Series E46 330i (M54) SAL
24 13 705
Replacing bearing on transmission extension
(A5S 325Z)
Necessary preliminary tasks:
•
Remove output flange
Caution!
After completion of work, check transmission oil level.
Use only approved transmission fluid.
Failure to comply with this instruction will result in serious
damage to the transmission.
Lift out circlip (1).
Remove ball ring (2).
Heat transmission extension in area of bearing race to approx. 80
°
C (hot air blower).
Remove bearing race (3).
Installation:
Install first ball ring (4), then bearing race.
Caution!
End play must be checked and if necessary adjusted.
RA Replacing bearing on transmission extension (A5S 325Z)
BMW AG - TIS
16.02.2013 01:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
