3 Series E46 330i (M54) SAL
Caution!
Position automatic transmission vertically on assembly stand,
converter bell housing points upwards.
Clutch packs must remain in installation position when
converter bell housing is removed.
Release screws.
Installation:
Screw centering pin (contained in repair kit) into transmission
housing.
Tighten down bolts diagonally and evenly.
Tightening torque: 23 Nm.
Remove sealing ring (1).
Installation:
Replace sealing ring (1).
Carefully remove converter bell housing with oil pump towards top.
Make sure clutch packs are not pulled out as well!
Clean sealing surfaces on transmission housing.
RA Installing converter bell housing/oil pump repair kit (A5S 360R / 390R)
BMW AG - TIS
16.02.2013 01:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
