3 Series E46 330i (M54) TOUR
11 36 575
Replacing solenoid valve for exhaust side on
VANOS adjustment unit
Special tools required:
•
11 6 420
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Check stored fault messages
•
Switch off ignition
E85 only:
•
Remove fluid tank for windshield washer system
Unlock plug (1) and remove.
Cut through cable tie (2).
Note:
Once it has been removed, oil drips from the solenoid valve.
Have a cleaning cloth ready.
Make sure no oil drips onto the belt drive. Remove any remnants
of oil immediately with cleaning cloth.
Release solenoid valve with special tool 11 6 420 .
Installation:
Tightening torque 11 36 1AZ
.
Now clear the fault memory.
RA Replacing solenoid valve for exhaust side on VANOS adjustment unit
BMW AG - TIS
15.02.2013 17:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -