3 Series E46 330i (M54) TOUR
11 53 000
Removing and installing/replacing coolant
thermostat (M52TU / M54 / M56)
Remove fan clutch with fan impeller and fan cowl.
Drain and dispose of coolant.
Note:
The water drain plug is located on the exhaust side on cylinder 2
in the engine block.
Installation:
Replacing sealing ring on water drain plug.
Tightening torque 11 11 5AZ .
Vent cooling system and check for leaks.
Pull locks and disconnect water hoses.
Installation:
Refer to general instructions for work on cooling system.
Loosen nut (1).
Release screws on thermostat housing, remove thermostat
housing.
RA Removing and installing/replacing coolant thermostat (M52TU / M54 / M56)
BMW AG - TIS
15.02.2013 17:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -