3 Series E46 330i (M54) TOUR
Push both gaiters onto constant velocity joints and tighten down
with hose clamps.
Note:
On transmission-side constant velocity joint, hose clamp fastener
(1) must be flush with rivet (2) on flange.
Install hose clamp fasteners on transmission-side and wheel-side
constant velocity joint offset by 180 degrees.
Check that gaiters are securely seated.
RA Replacing both gaiters on left and right of output shaft
BMW AG - TIS
15.02.2013 22:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -