3 Series E46 330i (M54) TOUR
41 61 014
Aligning hood lid
Note:
Engine hood was fitted and bolted in an unfinished body
shell.
Unpainted surfaces become visible after subsequent
movement.
These surfaces must be touched up with paint in the body
color.
Note:
The Bowden cable which connects both hood lid locks must
be completely seated in the guide in the lock on the left and
right.
If this is not the case, the Bowden cable will slip in the guide in
the lock after the release lever is pulled and the locks will not
open.
-
Preliminary work:
Unscrew detent buffers from left and right sides of hood lid.
Move stop disk of hood lid kidney
to position "0".
"0" points in direction of travel.
RA Aligning hood lid
BMW AG - TIS
16.02.2013 01:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -