3 Series E46 330xd (M57) SAL
27 21 020
Replacing radial shaft seal for output flange
Special tools required:
•
23 0 020
•
23 0 490
•
23 2 320
•
27 1 341
•
27 1 343
•
33 1 150
Important!
After completion of work, check transmission oil level.
Use only approved transmission oil.
Necessary preliminary tasks:
•
Remove exhaust system.
•
Detach propeller shaft at transfer case.
Secure output flange with special tool 23 0 020 .
Release nut (1) with special tool 23 2 320 .
Tightening torque: 27 00 6AZ
.
Installation:
Replace nut (1).
Secure nut (1) at points (2).
Note:
Illustration shows E53.
RA Replacing radial shaft seal for output flange
BMW AG - TIS
15.02.2013 21:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
