3 Series E46 330xd (M57) SAL
27 21 030
Replacing radial shaft seal for output front
axle
Special tools required:
•
23 0 490
•
27 1 341
•
27 1 342
Important!
After completion of work, check transmission oil level.
Use only the approved gear oil in this transfer case.
E46
E53
Necessary preliminary tasks:
•
Remove rear underbody protection from assemblies.
•
Remove front propeller shaft (E53).
•
Detach propeller shaft at transfer case (E46).
Press out drive flange (1) with a suitable tool (2) in direction of
arrow.
Illustration shows E46.
RA Replacing radial shaft seal for output front axle
BMW AG - TIS
15.02.2013 21:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -