3 Series E46 330xd (M57) SAL
31 51 020
Replacing radial seal on right output shaft
Special tools required:
•
31 5 130
After installation:
•
Check front differential oil level, correct if necessary
Note on E53:
Output shaft is not pressed out of drive flange.
Output shaft (1) and swivel bearing (2) remain together as a
single unit during removal and installation.
Note on E46:
Remove control arm from front axle carrier.
Output shaft is not pressed out of drive flange.
Swivel bearing (1), output shaft (2) and control arm (3) remain
together as a single unit during removal and installation.
RA Replacing radial seal on right output shaft
BMW AG - TIS
15.02.2013 21:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -