3 Series E46 330xd (M57) TOUR
Raise intake pipe (1) a little.
Unclip lines (2) from upper bracket.
Detach hose (3) on air cleaner housing.
Unclip lines (1) from lower bracket.
Detach hose (2).
Remove intake pipe (3).
Installation:
Apply a thin coat of petroleum jelly to sealing surfaces of
sealing rings (1).
Insert sealing rings (1) in intake snorkel.
Disconnect plug connection (2) on air-mass flow sensor.
Release screws (1).
Remove air-mass flow sensor.
Tightening torque,
refer to Technical Data 13 62 7AZ.
Interrogate fault memory of DDE control unit.
Check stored fault messages.
Rectify fault and clear fault memory.
RA Removing and installing/replacing air-mass flow sensor (M57)
BMW AG - TIS
15.02.2013 22:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
