3 Series E46 330xd (M57) TOUR
32 31 215
Removing and installing/replacing double
joint for steering spindle lower section (AWD)
Necessary preliminary tasks:
•
Remove underbody protective plate
•
M54: Remove intake filter housing
•
M57: Remove acoustic insulation from engine carrier on left
After installation:
•
Carry out steering angle sensor adjustment
Release clamping screw.
Move steering wheel to straight-ahead position and remove
ignition key.
Detach double joint from power steering gear.
Installation:
If necessary, move power steering gear to straight-ahead position
- markings on cap and housing must match up.
Replace clamping screw.
Clamping screw must rest in groove of steering shaft.
Tightening torque 32 31 1AZ
.
Release clamping screw.
Remove double joint with lower section of steering spindle.
Installation:
Lower section of steering spindle can only be attached in one
position to the steering column.
Replace clamping screw.
Tightening torque 32 31 1AZ
.
RA Removing and installing/replacing double joint for steering spindle lower sectio
BMW AG - TIS
16.02.2013 01:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -