3 Series E46 330xd (M57) TOUR
Important!
Adhere to the following installation sequence in order to
prevent distortion of the rear differential during installation and
thereby avoid potential complaints about noise.
Installation sequence:
1.
Install rear differential with workshop jack and special tool
33 4 420 .
2.
Insert bolts (1) (do not tighten down)
3.
Insert bolt (2), replace and screw on nut (3) (do not tighten
down).
4.
Lower workshop jack and place to one side
5.
Tighten screws (1)
Tightening torque 33 17 1AZ
.
6.
Tighten screw (2)
Tightening torque 33 17 1AZ
.
Replacement:
If necessary, modify vibration damper with bracket.
After installation:
•
Replacement only:
-
Add rear differential oil
•
Check rear differential oil level, correct if necessary
RA Removing and installing/replacing rear differential
BMW AG - TIS
16.02.2013 02:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -