3 Series E46 330xd (M57TU) SAL
Note:
For purposes of clarity, this work step is shown from above and
without the heater bulkhead. Bolts (1) are released from below.
Rear-wheel drive:
Release bolts (1).
All-wheel drive:
Release starter mounting bolts (1) from transmission output end
with a long extension and a universal joint.
Rear- and all-wheel drives:
Withdraw starter motor (1) from transmission flange and tilt out
past engine carrier.
Installation:
Tightening torque 12 41 4AZ
.
RA Removing and installing/replacing starter motor (M57, M57TU)
BMW AG - TIS
15.02.2013 23:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
