3 Series E46 330xi (M54) SAL
00 11 500
Checking/topping up fluid level in automatic
transmission (A5S 325Z)
Caution!
Automatic transmission fluid!
It is absolutely essential to use the approved automatic
transmission fluid in this automatic transmission,
refer to BMW Operating Fluids MG24.
Failure to comply with this requirement will result in serious
damage to the automatic transmission!
1. Add ATF after repairs:
Selector lever to setting "P".
The vehicle must be horizontal and should be secured to prevent
it from rolling away.
Connect BMW Diagnosis and Information System (DIS) or BMW
MoDiC to car.
Note:
Before releasing filler plug (1), make sure temperature of
automatic transmission fluid is
≤
30
°
C.
Release filler plug (1).
Top up automatic transmission fluid until it flows over.
Screw in filler plug (1) by hand.
Start engine and run at idle speed.
Operate brake and shift through all gears at idle speed several
times (hold gears for 3 sec. in each case).
Note:
Before releasing filler plug (1), make sure temperature of
automatic transmission fluid is
≤
30
°
C.
Release filler plug (1) again.
Top up automatic transmission fluid until it flows over.
Increase temperature of automatic transmission fluid to
40 ... 50
°
C.
Check temperature of automatic transmission fluid with MoDiC or
DIS.
Screw in filler plug (1).
Installation:
Replace filler plug (1).
Tightening Torque,
refer to Technical Data 24 11 7AZ.
RA Checking/topping up fluid level in automatic transmission (A5S 325Z)
BMW AG - TIS
16.02.2013 06:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
