3 Series E46 330xi (M54) SAL
Unfasten oil sump screws at transmission and engine ends.
Lower and remove oil sump.
Installation:
Sealing faces clean and free of seal debris.
Apply approx. 3 mm wide, 2 mm high coat of Drei Bond 1209
sealing agent (refer to BMW Parts Service) to the area around
seams.
Installation:
1.
Replace gasket
2.
Install oil sump.
3.
Insert all oil sump screws.
4.
Insert screws in transmission end without preload at this
stage.
5.
Tighten down screws in engine end.
6.
Tighten down screws in transmission end.
RA Removing and installing, sealing or replacing oil sump (M52TU / M54 / M56)
BMW AG - TIS
16.02.2013 06:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
