3 Series E46 330xi (M54) SAL
Raise engine with special tool 00 0 200 approx. 5 mm.
Remove microfilter.
Open cable duct on lower section of microfilter housing (2) and
feed out cable(s).
Release screws (1) and remove lower section of microfilter
housing (2).
Remove cover from fuel injectors.
Caution!
Do not mix up oxygen monitor sensors for cylinders 1 to 3
and 4 to 6 at plug connection to wiring harness.
Mark plug connections.
Unclip the cable from the retainer. Disconnect plug. Unclip cable
on rear side of engine from cable guide.
Remove engine splash guard.
Remove exhaust system.
Note:
The oxygen sensors are in danger of being damaged when the
exhaust manifolds are removed and installed.
Remove oxygen monitor sensors.
Remove oxygen control sensors.
RA Removing and installing both exhaust manifolds with catalytic converter (M54 4WD
BMW AG - TIS
16.02.2013 07:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
