3 Series E46 330xi (M54) SAL
12 41 020
Removing and installing/replacing starter
motor (M54 4WD)
Special tools required:
•
00 2 030
•
24 5 301
•
24 5 305
Follow instructions for disconnecting and connecting battery.
Disconnect and cover battery negative terminal.
Release screws (1) and remove cover (2).
Note:
To release the starter motor bolt connection on the transmission, it
is necessary to lower the transmission by approx. 5 cm.
Lowering the transmission is described in the section "Removing
and installing transmission".
To lower transmission:
•
Remove intake hood.
•
Remove underbody protection.
•
Remove exhaust system.
•
Remove heat shield.
•
Remove shift lever and cable.
•
Detach propeller shaft from transmission and tie back to one
side.
•
Remove front propeller shaft.
•
Support transmission with special tool 00 2 030 /
24 5 301 / 24 5 305 .
RA Removing and installing/replacing starter motor (M54 4WD)
BMW AG - TIS
16.02.2013 07:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
