3 Series E46 330xi (M54) SAL
All cars:
Unlock plug (1) and detach from throttle assembly (3).
Release screws (2) and remove throttle assembly (3).
Installation:
Replace sealing ring (1) between throttle assembly and intake
manifold.
Note:
A faulty throttle adjusts the adaptation values stored in the DME
control unit. These adaptation values must be reset after the
throttle assembly has been replaced.
Clearing adaptation values:
-
Connect DIS Tester
-
Select vehicle type
-
Select "DME Motor Electronics MS43",
carry out individual brief test
-
Continue with bottom right arrow
-
The "Fault pattern selection" window appears.
Select "Function selection" (bottom left)
-
The "Function and component selection" window appears:
-
Select "Service functions"
-
Select "Drive"
-
Select "Digital Motor Electronics"
-
Select "Reset adaptations"
-
Select "Test schedule" (bottom left)
-
The "Test schedule" window appears.
Select "Reset adaptations"
-
Continue with bottom right arrow
For subsequent procedure, follow DIS instructions.
RA Removing and installing/sealing throttle assembly (M54)
BMW AG - TIS
16.02.2013 07:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -