3 Series E46 330xi (M54) SAL
13 71 000
Remove and installing intake filter housing
(M52TU, M54, M56)
Turn off ignition.
Detach holder (1) for engine wiring harness.
Unlock retainers (2) and release screws (3).
Remove intake filter housing.
Installation:
Check seal (1) between air-mass flow sensor and air cleaner
upper section for damage; replace if damaged.
To facilitate joint between air cleaner and throttle assembly, coat
gasket with acid-free grease.
M52TU only:
Installation:
Insert guide pin (1) on intake filter housing into bore hole (2) in
rubber mount.
RA Remove and installing intake filter housing (M52TU, M54, M56)
BMW AG - TIS
16.02.2013 07:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
