3 Series E46 330xi (M54) SAL
Release screws.
Tightening torque, 23 00 1AZ.
Pull out transmission towards rear as far as possible, turn
counterclockwise and remove.
Installation:
Pay attention to dowel sleeves.
Replace damaged dowel sleeves.
Ensure correct position of cover plate.
Installation:
Remove release unit and release lever, clean and apply
grease to relevant points.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, replace clutch plate.
Check clutch plate for friction rust in taper splines and replace
if necessary.
Mechanically remove old grease and lining abrasion from
taper splines of clutch plate (with a cloth).
Then apply a thin and even coat of grease with a brush in
entire area of taper splines. Also in taper groove and on guide
pin.
RA Removing and installing transmission (S5D 320Z, 4WD)
BMW AG - TIS
16.02.2013 09:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
