3 Series E46 330xi (M54) SAL
32 13 060
Removing and installing power steering gear
(4WD)
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off pipe connections with plugs.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment
Necessary preliminary tasks:
•
Draw off and dispose off hydraulic fluid from fluid reservoir
Observe country-specific waste-disposal regulations
•
Remove underbody protective plate
•
Remove tie rod end on both sides from swivel bearing
•
Remove flexible disk/universal joint from power steering gear
Release banjo bolts.
Disconnect hydraulic lines from power steering gear.
Installation:
Replace sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 32 41 3AZ
.
Lower front axle support.
Unfasten screws.
Remove power steering gear.
Installation:
Replace screws and self-locking nuts.
Tightening torque 32 00 1AZ
.
RA Removing and installing power steering gear (4WD)
BMW AG - TIS
16.02.2013 11:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -