3 Series E46 M3 CSL (S54) COUPE
Release nut.
Remove holder (1).
Unclip plug connection (2) and disconnect.
Release screw connection of flanges at exhaust manifold.
Installation:
Check seals and replace if necessary.
Replace self-locking nuts and screws.
Coat thread with copper paste, refer to BMW Parts Service.
Preliminary tightening:
Tighten screws alternately to locate relevant flange pair.
Final tightening:
Tighten screws to specified
tightening torque, 18 00 1AZ.
Support catalytic converter with jack and special tool 31 2 220
and secure against falling out.
Release screw connection of intermediate pipes at both catalytic
converters.
Installation:
Check seals and replace if necessary.
Replace self-locking nuts and screws.
Coat thread with copper paste, refer to BMW Parts Service.
RA Removing and installing/replacing catalytic converter (S54)
BMW AG - TIS
16.02.2013 17:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -