3 Series E46 M3 CSL (S54) COUPE
Disconnect cable plug (1) from reverse gear switch and from gear
detection switch (2).
Detach cable from fixtures.
Release screws.
Tightening torque, 26 11 1AZ.
Installation:
Replace self-locking nuts.
Grip propeller shaft and release nuts.
Tightening torque, 26 11 6AZ.
Bend propeller shaft downwards at center bearing (1).
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
Note:
Pressure line remains connected.
Release nuts and remove clutch slave cylinder.
Tightening torque, 21 52 5AZ.
Caution!
Slowly relieve tension on clutch slave cylinder during removal
as otherwise air will be drawn in through sealing sleeve.
RA Removing and installing transmission (S6S 420G)
BMW AG - TIS
16.02.2013 17:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -