3 Series E46 M3 CSL (S54) COUPE
Note:
Two covered (1) removal holes are located on the end face of
the radial sealing ring.
Screw special tool 23 0 490 into one of the two removal holes.
Pull radial seal out of transmission housing with aid of impact
weight.
Connect special tool 23 2 492 together (cap and sleeve).
Coat sealing lips of radial seal with gear oil and push onto special
tool.
Remove cap.
Push sleeve with radial seal onto drive shaft.
RA Replacing radial seal on input shaft (S6S 420G)
BMW AG - TIS
16.02.2013 17:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -