3 Series E46 M3 CSL (S54) COUPE
Remove side heat shield (1).
Remove bracket for underbody protection at rear.
Release screws.
Installation:
-
Replace self-locking nuts
-
Tightening torque: 26 11 1AZ
Grip propeller shaft and release nuts.
Installation:
-
Tightening torque: 26 11 6AZ
Bend propeller shaft downwards at center bearing (1).
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
Support transmission with special tools 00 2 030 and 23 0 040
(23 0 041 and 23 0 042).
RA Removing and installing/replacing actuator (S6S 420G SMG)
BMW AG - TIS
16.02.2013 17:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -