3 Series E46 M3 CSL (S54) COUPE
Install side panel reinforcement spare part and locate in position.
Note:
During installation, make sure the clips are passed through
the bores provided.
Pull clips with pliers through bores until they are locked.
The clips serve to secure the shaped part for the cavity bulkhead
to the side panel reinforcement.
Fitting shaped part for cavity bulkhead on cars without slide/tilt
sunroofs:
Mount shaped part for cavity bulkhead (1) on side panel
reinforcement spare part.
Apply window adhesive approx. 20 mm high to foam section on
contact surface of spare part.
Fit spare part and locate in position.
Note:
During installation, make sure the clips are passed through
the bores provided.
Pull clips with pliers through bores until they are locked.
The clips serve to secure the shaped part for the cavity bulkhead
to the side panel reinforcement.
RA Replacing rear left or right outer wheel arch section (side panel removed) (E46
BMW AG - TIS
16.02.2013 21:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 16 -