3 Series E46 M3 (S54) CONVER
Installation:
Sealing faces clean and free of seal debris.
Check seal, replace if necessary.
Apply Drei Bond 1209 sealing compound to area around
joint (refer to BMW Parts Service): approx. 3 mm wide and
2 mm high.
Installation:
1)
Install oil sump.
2)
Install all oil pan screws
3)
Insert screws in transmission end without preload at this
stage.
4)
Tighten down screws in engine end.
5)
Tighten down screws in transmission end.
RA Removing and installing, sealing or replacing oil sump (S54)
BMW AG - TIS
16.02.2013 08:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
