3 Series E46 M3 (S54) CONVER
Tighten down six accessible screws (three on exhaust side and
three on inlet side) on VANOS gear to 14 Nm.
Remove special tool 11 2 300 . Rotate crankshaft in direction
of rotation a further revolution up to overlap TDC position.
Note:
TDC allocation above marking on vibration damper is sufficient.
Note:
Use special tool 11 7 200 to tighten down bolts on VANOS gear.
Tighten down remaining six screws (three on exhaust side and
three on inlet side) on VANOS gear to 14 Nm.
RA Replacing camshafts (S54)
BMW AG - TIS
16.02.2013 08:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 27 -