3 Series E46 M3 (S54) CONVER
12 41 020
Removing and installing/replacing starter
motor (S54)
Observe instructions for disconnecting and connecting battery.
Disconnect battery negative lead from battery.
Remove rear underbody protection.
Remove reinforcement plate on front axle support.
Important!
The section "Removing and installing reinforcement plate on
front axle support" contains important installation instructions.
Note:
For a better overview, this work step is shown from above and
without the intake air manifold. Do not remove intake air manifold
and carry out work from below.
Release nuts.
Installation:
Tightening torque, 12 41 4AZ.
Disconnect battery positive leads from starter motor.
Disconnect lead from starter motor.
Note:
For a better overview, the illustrations of other BMW cars are used
for the following work steps.
RA Removing and installing/replacing starter motor (S54)
BMW AG - TIS
16.02.2013 09:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
