3 Series E46 M3 (S54) CONVER
Detach plug connections of wiring harness section for ignition coils
in electronics box. This task is described in the section "Replacing
control unit".
Detach strip on left equipment partition wall.
Withdraw wiring harness section for ignition coils from left
equipment partition wall and remove.
Installation:
Pay attention to correct installation position of seal from wiring
harness section for ignition coils in left equipment partition wall.
Note:
Interrogate fault memory of DME control unit.
Check stored fault messages.
Rectify faults.
Then clear fault memory.
RA Replacing wiring harness section for ignition coil (S54)
BMW AG - TIS
16.02.2013 09:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
