3 Series E46 M3 (S54) CONVER
21 XX X
Pressure reduction in hydraulic unit
(S6S 420G SMG)
Note:
After completing work:
Read out fault memory and clear fault entries.
Release screws (1).
Remove cover.
Installation:
Correctly install wiring harness with grommet in cover (water
tightness).
Suspend cover (3) in hinges of underside of electronics box (1).
Make sure upper stop (2) is correctly installed above hinges of
electronics box lower section.
Detach relay (1) of hydraulic pump.
Installation:
Before inserting relay (1), start following service functions:
-
Transmission actuator
-
Clutch slave cylinder
RA Pressure reduction in hydraulic unit (S6S 420G SMG)
BMW AG - TIS
16.02.2013 10:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
