3 Series E46 M3 (S54) CONVER
Unfasten screws.
Tightening torque, 26 11 1AZ
.
Installation:
Replace self-locking nuts.
Tighten mounting screws of flexible disk on transmission
flange by means of nuts only.
Grip propeller shaft and release nuts.
Tightening torque 26 11 6AZ
.
Bend propeller shaft downwards at center bearing (1).
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
Lever out retaining ring (1) with a screwdriver.
Push retaining ring (1) forwards slightly.
Drive out retaining pin (1) on selector rod linkage with special
tool 23 0 240 .
Note:
To remove retaining pin (1):
slide selector rod into transmission.
RA Removing and installing transmission (S6S 420G SMG)
BMW AG - TIS
16.02.2013 11:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
