3 Series E46 M3 (S54) CONVER
Important!
Never re-use a rubber mount pulled off control arm. Rubber-
coated inner sleeve is destroyed when pulled off dry.
Detach bracket with special tools 00 7 500 and 31 2 151 from
control arm.
Important!
If the position of the rubber mount is not strictly adhered to,
this will result in impaired vehicle handling and early rubber
mount wear!
Mark dimension (A) = 299
±
2 mm on control arm pin.
Note:
Outer edge of rubber mount must be flush with marked
dimension (A).
Important!
The larger diameters of bores (2) in the bracket must point to
the engine carrier.
Make sure there is a positive lock (1) between rubber mount
bushing and control arm pin.
Coat control arm pin and rubber mount bushing with soap water.
Mixture ratio: 1 part soap to 20 parts water.
RA Replacing bracket for control arm (M3)
BMW AG - TIS
16.02.2013 11:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
