3 Series E46 M3 (S54) CONVER
34 33 505
Removing and installing/replacing brake
booster (M3)
Note:
Read and comply with General Information.
Bleed brake system after completing tasks.
Remove brake master cylinder.
Remove DSC3 precharging pump.
Remove cover from electrical box.
Remove brake pedal.
Unscrew nuts (1).
Installation:
Replace self-locking nuts.
Tightening torque, 34 33 12AZ.
Note:
Do not use force when removing and installing the brake booster
as this may damage the booster.
Pull wiring harness (2) out of partition wall.
Carefully pull brake booster (1) out of bulkhead.
Remove brake unit vertically upwards out of equipment
compartment.
RA Removing and installing/replacing brake booster (M3)
BMW AG - TIS
16.02.2013 14:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
