3 Series E90 316i (N45) SAL
Bearing caps of inlet camshaft are marked E1 to E4 from inlet
side.
Lubricate inlet camshaft and bearing caps with engine oil.
Fit bearing caps of inlet camshaft.
Note:
Retaining clips (1) for oil line are fitted on bearing
caps 1 and 4.
Insert all nuts and install without play.
Tighten down nuts on bearing caps in 1/2 turn increments from
inside outwards.
Tightening torque, 11 31 1AZ
.
Fit bearing bracket (1).
RA Removing and installing/replacing inlet camshaft (N40 / N45)
BMW AG - TIS
18.01.2013 08:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -