3 Series E90 316i (N45) SAL
13 71 000
Removing and installing intake filter housing
Necessary preliminary tasks:
•
Switch off ignition
•
Remove intake duct
Release clamp (1).
Pull off rubber cap (2) and disconnect plug connection beneath.
Installation:
Ensure correct installation position and that there are no leaks.
If necessary, unclip holder (3) and coolant hose.
Installation:
Pay attention to installation position of coolant hose, risk of
damage!
Release screws.
Remove intake filter housing (4).
RA Removing and installing intake filter housing
BMW AG - TIS
18.01.2013 09:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -