3 Series E90 316i (N45) SAL
Carry over the work step shown symmetrically to the other side of
the vehicle.
Mark severance cut (1) and cut.
Open weld joints in areas (2).
Installation:
Weld new components in areas (3) additionally.
Carry over the work step shown symmetrically to the other side of
the vehicle.
Mark severance cut (1) in accordance with measurement a and
cut rear axle carrier.
Important!
Cut outer metal sheet only.
Measurement a=70 mm from rear axle bushing mounting.
Open weld joints in area (2).
Installation:
Weld in reinforcement plates at severance cuts.
Carry over the work step shown symmetrically to the other side of
the vehicle.
Open weld joints in areas (1).
Saloon and Coupé only:
Carry over the work step shown symmetrically to the other side of
the vehicle.
Open weld joints in area (1).
Installation:
Weld new components in areas (2) additionally.
RA Replacing luggage compartment floor (complete with both inner wheel arch section
BMW AG - TIS
18.01.2013 11:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
