3 Series E90 316i (N45) SAL
1
Folding pack, head airbag
4
Holders, folding pack, screwed
2
Ramp, B-pillar
5
End fittings, A- and D-pillars
3
Gas generator
Release screw (1) on end fitting.
Tightening torque 72 12 05AZ
.
Release screw (2) on folding pack holder.
Tightening torques 72 12 04AZ
.
Folding pack holder (3) is screwed to trim for roof pillar at front.
Installation:
If screws (1...3) slip, coat them with Loctite.
If necessary, lever out clip-mounted holder.
If necessary, slide wiring harness (2) to one side to release
screw (1) on folding pack holder.
Tightening torque 72 12 04AZ
.
Release screw (3) from folding pack holders.
Tightening torques 72 12 04AZ
.
Installation:
If screws (1) and (3) slip, coat them with Loctite.
If necessary, lever out clip-mounted holder.
Unlock plug connection (4) and disconnect.
Release screws (1) on B-pillar ramp.
Tightening torque 72 1206AZ .
Unscrew bolt (3).
Tightening torque 72 12 03AZ
.
Remove gas generator (5) with head airbag.
RA Removing and installing/replacing left or right head airbag
BMW AG - TIS
18.01.2013 16:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
