3 Series E90 316i (N45T) SAL
Installation:
Illustration with engine removed.
Cylinder head, front:
Remove all sealing remnants from sealing surfaces of cylinder
head.
Apply a thin, uniform bead of Drei Bond 1209 sealing agent
(refer to BMW Parts Service) to transition area of half-moon
sections.
Installation:
Illustration with engine removed.
Cylinder head, rear:
Remove all sealing remnants from sealing surfaces of cylinder
head.
Apply a thin, uniform bead of Drei Bond 1209 sealing agent
(refer to BMW Parts Service) to transition area of half-moon
sections.
Installation:
Make sure gasket is correctly seated on cylinder head at front.
Tightening torque 11 12 4AZ
.
Note:
Illustration with engine removed.
Make sure gasket is correctly seated on cylinder head at rear.
Installation:
Tighten down all screws in diagonal sequence from inside
outwards.
Tightening torque 11 12 4AZ
.
RA Removing and installing/sealing cylinder head cover (N45T)
BMW AG - TIS
19.01.2013 01:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
