3 Series E90 316i (N45T) SAL
Important!
The following text describes installation and sealing between
the engine block and radial shaft seal.
The engine block will not be leakproof at the outside of the
radial seal if you fail to comply with the individual work steps
and the work sequence.
Note:
The required parts are available from the BMW Parts Service
(ETK).
Remove screw caps (1) from injector (2).
Screw on needle and insert plunger.
Injector (2) contains the sealing compound Loctite,
manufacturer's number 128357.
Bottle (3) contains the primer Loctite, manufacturer's
number 171000.
Push support sleeve (1) with radial shaft seal (2) onto special
tool 11 9 232 .
Important!
Support sleeve (1) remains on special tool
11 9 232 until
radial shaft seal is drawn in.
Align groove (3) centrally to housing partition (4).
Coat both grooves (3) on radial shaft seal (2) with Loctite primer,
manufacturer's number 171000, and expose to air for approx.
one minute.
Draw in radial shaft seal with special tool 11 9 231 in
conjunction with special tool 11 9 233 until flush.
RA Replacing front crankshaft seal (N45T)
BMW AG - TIS
19.01.2013 01:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
