3 Series E90 316i (N45T) SAL
Ends of compression rings (1) point upwards.
Make sure compression rings (1) are engaged at ends.
Bearing caps of inlet camshaft are marked E1 to E4 from inlet
side.
Lubricate inlet camshaft and bearing caps with engine oil.
Fit bearing caps of inlet camshaft.
Note:
Retaining clips (1) for oil line are fitted on bearing
caps 1 and 4.
Insert all nuts and install without play.
Tighten down nuts on bearing caps in 1/2 turn increments from
inside outwards.
Tightening torque 11 31 1AZ
.
RA Removing and installing/replacing inlet camshaft (N45T)
BMW AG - TIS
19.01.2013 01:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
