3 Series E90 316i (N45T) SAL
Release spindle (1) until load is fully removed from diaphragm
spring (2).
Release knurled screw (1) and remove special tool 21 2 170
from SAC clutch.
Release knurled screws (1) and remove special tool 21 2 190
from SAC clutch.
Important!
If special tool 21 2 190 cannot be removed from SAC
clutch,
proceed as follows:
-
Fit special tool 21 2 170 on SAC clutch and secure.
-
Screw in spindle up to diaphragm spring.
-
Screw in spindle approx. 1 turn over contact pressure of
diaphragm spring.
-
Remove special tool 21 2 190 from SAC clutch.
-
Remove special tools 21 2 170 and 21 2 190 from SAC
clutch.
RA Removing and installing/replacing clutch (SAC 228 N45/N46/N45T/N43/N46T)
BMW AG - TIS
19.01.2013 01:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -