3 Series E90 316i (N45T) SAL
32 31 102
Replacing steering spindle sleeve
Necessary preliminary tasks:
•
Remove lower section of steering spindle
Push steering spindle into steering column.
Pop sleeve (1) out of bulkhead, press together and remove.
Installation:
Detach pull-in lug from sleeve and lubricate gap with silicone
grease.
Press sleeve together, slide onto steering column, align to
opening in bulkhead and insert in bulkhead.
Note:
To prevent the sleeve from slipping out and to avoid complaints by
the customer about noise, make sure that sealing lip (1) on
engine compartment side rests against bulkhead all round and
sealing lip (2) in inside the car rests against the damping.
After installation:
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
RA Replacing steering spindle sleeve
BMW AG - TIS
19.01.2013 02:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -