3 Series E90 318d (N47) SAL
12 51 200
Replacing wiring harness section for injectors
(N47)
Necessary preliminary tasks:
-
Read fault memory of DDE control unit
-
Switch off ignition
-
Disconnect battery negative lead
-
Remove acoustic cover
-
Remove microfilter housing
-
Unscrew battery positive lead from alternator and lay to one
side
Information on E83 electronics box at: Remove control unit.
Unlock fasteners (1) from below and slide upwards approx.
10 mm.
Unlock locks (2) in direction of arrow.
Remove cover (3).
Unlock plug (1) from DDE control unit and detach in upward
direction.
Press out retaining clip (1) with a small screwdriver approx.
2 mm in direction of arrow.
Pull out plugs (2) towards rear.
Installation:
Insert plugs and slide retaining clip back.
Check that plugs (2) are firmly seated.
RA Replacing wiring harness section for injectors (N47)
BMW AG - TIS
20.01.2013 09:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -