3 Series E90 320i (N43) SAL
Do not under any circumstances pull injector out of bore!
If the injector is pulled out of the bore hole, the PTFE sealing
ring must be replaced! Replacing PTFE sealing ring, refer to
13 53 310 .
Tighten down screw for holding-down element (1).
Tightening torque 13 53 1AZ
.
Loosen bolts of high-pressure pump (1).
Note:
•
Loosen bolts only to such an extent that the high-pressure
pump can still be moved direction of arrow.
Install delivery line (1).
Important!
Connect pressure line (1) without tension only.
Nuts (3) must be able to be screwed on easily by hand.
If necessary, turn high-pressure pump (2) to align in direction
of arrow.
RA Removing and installing or replacing high-pressure rail (N43)
BMW AG - TIS
25.01.2013 04:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
