3 Series E90 320i (N43) SAL
Important!
Fit screw cap without using a tool and tighten hand-tight.
Then tighten screw cap with special tool 16 1 020 until
notch (1) points to marking (2).
Note:
Illustration shows the tank removed.
Carefully raise service cap (1).
Unlock and detach vent line (2).
Installation:
Clean sealing faces and install new seal (3).
Make sure that the lever sensor moves freely before fitting the
service cap.
Locating rods (4) must fit correctly in the hole of the delivery unit.
Installation:
Service cap can only be installed in one position.
When installing, make sure lug (1) of service cap engages in
corresponding opening (2) on fuel tank.
Disconnect plug connection (1).
Installation:
Connect cable with cable tie (2).
Ensure correct routing of cables.
RA Removing and installing or replacing fuel pump (petrol/gasoline)
BMW AG - TIS
25.01.2013 04:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
