3 Series E90 320i (N43) SAL
32 13 060
Removing and installing/replacing power
steering gear
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove front underbody protection
•
E88, E93: Remove V-strut on left and right
•
Remove both tie rod ends from swivel bearing
•
Replacement only: Remove both tie rod ends from tie rod
•
Remove lower steering spindle from power steering gear
If necessary, remove heat shield from power steering gear.
Release banjo bolts (1, 4).
Disconnect pressure line (2) and return line (3) from power
steering gear.
If necessary, remove hydraulic lines with bracket from power
steering gear.
Installation:
Replace all sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
RA Removing and installing/replacing power steering gear
BMW AG - TIS
25.01.2013 06:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
