3 Series E90 320i (N46) SAL
Centre clutch plate (1) with special tool 21 2 250 .
Fit SAC clutch (1) on flywheel.
Pay attention to dowel pins (2).
SAC clutch (1) must be secured by way of dowel pins (2).
Install retaining screws of SAC clutch and tighten down.
Tightening torque: 21 21 1AZ
.
Release spindle (1) until load is fully removed from diaphragm
spring (2).
Release knurled screw (1) and remove special tool 21 2 170
from SAC clutch.
RA Removing and installing/replacing clutch (SAC 228 N45/N46/N45T/N43/N46T)
BMW AG - TIS
26.01.2013 04:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
