3 Series E90 320i (N46) SAL
41 12 560
Replacing luggage compartment floor
(complete with both inner wheel arch
sections, tail panel removed)
Read contents of Body, General.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 12 560).
Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.
Spot-weld bonding is used on this vehicle. Observe specific
procedure.
Use only approved spot-welding apparatus for repairs!
Place vehicle on straightening bench.
Following new body parts are required (refer to Electronic Parts
Catalogue ETK):
-
(1) Luggage compartment floor, upper section
-
(2) Rear axle carrier
-
(3) Wheel arch, rear, inner half, left
-
(4) Wheel arch, rear, inner half, right
-
Touring only:
(5) Bracket, tension strut, rear (2 x) (not shown)
Carry over the work step shown symmetrically to the other side of
the vehicle.
Mark severance cut in accordance with measurement a and cut.
Measurement a=40 mm behind support, frame side
member (1).
Installation:
Weld in reinforcement plates at severance cuts.
RA Replacing luggage compartment floor (complete with both inner wheel arch section
BMW AG - TIS
26.01.2013 08:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -